Subject | Text |
| I do not have specific information concering this monitor.
The colors on the monitor cables are no |
| I would still start with checking the voltages on the secundairy part of the power supply.
e.g. D |
|
| the fault is in the akb (auto geyscale) circuit area of the tv, start by checking the a1 voltage is |
| Thank you so much for the detailed answer.
I'll have a go at it over the weekend.
I might not ha |
Toshibas and the like | Hi there Larry and Tibor,
last night I repaired my Toshiba. Larry, you are completely right, the |
| The primary circuit is the part from where your power cable enters, till the transformer.
And yes |
Re: Infinity SSW 210 has no audio output | [quote:1de8dce7bb="CQNoAudio"]:?: Has anyone found a Service Manual for the Infinity SSW-210 or bett |
| And the voltages? |
Update to Sony KV35V76 on / off Picture | The KV35V76 is part of the KV32V36/32V36/34V36C and KV35V35/37V36M family
When the picture disapp |
| Being a switchmode powersupply I would not run it without a load otherwise it may self destruct. Plu |
ak19 | [b:d7090ddf95][i:d7090ddf95] :D firstl check the 2,2 ohms fusible for oc,(ew circuit),check c630 for |
Mitsubishi WS 55711 DEAD | The WS 55711 will not turn on. The LED on the front will flash when the TV is reset. All the standby |
| Hi Andreas! In your amplifier check the outputs Transistors and the voltages to them. |
| 6, 8, 12 and 14 are the "common" voltages. 35mA and 70mA are the "common" curren |
Faulty gate motor | It's a sliding gate, motor looks like a car wiper motor, I checked connections etc, seems to be fine |
| I use to come across this on variety of different brands. Sort of a catastrophic failure where the d |
Sony TV Model KP-53XBR35 Power Supply problems | Have been troubleshooting captioned for several hours. All DC voltages are either low or zero. Canno |
|
| It sounds like a verticle deflection problem. You can try replacing the verticle output IC and assoc |
| JUDGING OFF THE FLARING YOU ALSO HAVE, I WOULD SAY THE CRT IS LOW EMMISION AND THAT THE AUTO GREY SC |
| Correction.
I do get the correct voltages, but the relay shuts down.
This is true with or without |
| A CRT (picture tube) have 3 electron guns,each with their own filament, (heater) so you should see a |
Re: DVD Stucked on Standby | [quote:8d52754975="Eduardo"]Hello, I have a JVC DVD Player model XV-N312S and is stucked in Standby |
TechLine 37" LCD TV green color instead black | >Sounds like a cable unplugged or a bad T-con board.
Cables are OK,btw what is T-con board???? |
Need schematic Samsung SV-DVD50 | Hi everybody
I am looking for scematic to above mentioned vcr/dvd combination
och perhaps tips. |
hitachi 53f300, dp25h chassis. deflection board problems | I got this tv from a friend after it quit working, I have replaced the power pwb, and I have replace |
B&K AVR-507 service manual needed | I have a B&K AVR-507 that will not power up. Turn on power and the output relays click on then |
| Hmmm. This could be a pain in the arse, but maybe not. It is possible that there is a missing low vo |
Re: monitor Samsung AQ17KS horiz output very hot | [quote:e14f445e0e="Divanil"]Hi,
I have a monitor samsung syncmaster 753dfx chassi aq17ks and the ho |
| if it is not recognising dvds but cds are fine it is going to be the laser assembly. if you want the |
dp42sp | hi, im new here. I have a 42' plasma dawoo that broke yesterday. the bottom half of the screen wen |